Most general food plant foaming applications Connect to foaming unit and adjust air/water pressure and detergent feed until the desired foam density is achieved. Cover surfaces and equipment with foam and allow 5-10 minutes for a full sanitising process to take effect. For manual cleaning Use at a ratio of 1:99 to 1:49 (1-2% soln, 10-20mls per litre) with potable water. Not for use on aluminium or soft metals as corrosion or oxidation may quickly occur. A 1% solution yields 450 ppm of Free Available Chlorine (when product packed).
Under Good Practice Protocol based on accepted international research a 2% solution of this product diluted with potable water is recommended with liberal application on clean hard surfaces with a minimum contact time of 5 minutes. At this concentration the product provides 600PPM FAC.
This product not quite right? We've picked out a few more that may suit your application. Alternatively contact your Kemsol representative or email Kemsol for more information.
Foam-Force (5L) | FK-FOAFO05 |
Foam-Force (20L) | FK-FOAFO20 |
Foam-Force (200L) | FK-FOAFO200 |
We are committed to continual improvement in our environmental performance, and have established a number of goals and initiatives helping achieve this objective.
Where possible we always use biodegradable raw materials and all our finished product packaging is reusable or recyclable.
This is only a start, we continually strive to better our environmental performance. Visit chemicalsolutions.co.nz for more information.
©2024 Kemsol. Site by Zulu Shopfront
A handy guide containing all our Kemsol products with MPI approval
Click to get your copy